Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
How to maintain plastic injection molds?
1. Clean the upper and lower surfaces of the injection mold before installing the mold to ensure the correct cooperation between the installation surface of the injection mold and the press table.
2. Open the mold after the mold is installed, and clean the mold guiding mechanism and the surface of the mold cavity to ensure the quality of the parts.
3. Lubricate or apply grease to each sliding part of the mold.
4. Check and maintain the side guard plate, and clean up the punching waste path and hole.
5. Check mold safety side pins, safety screws and other safety parts, find problems, repair and replace them in time.
New plastic products or plastic sample parts are normally produced by plastic injection molds. Injection molds are usually made of a specified steel metal with good thermal conductivity. In addition...
Ceeto Mold has rich experience to design high quality plastic injection molds, here we summarize 6 key points how to design well about plastic injection molds. Key point 1: Firstly we have to define...
PC plastic resin is polycarbonate which is widely used in plastic injection molding industry and because of its excellent mechanical properties, plastic injection molding business is one of our main...
Ceeto Company has been dedicated to design and manufacture plastic injection mold for over 10 years, business refers to Automotive Industry, Home Appliance Industry, Daily Commodities Industry,...
Email to this supplier
June 06, 2021
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.